Table of Contents
Advertisement
4
Product manual - IRT 710
3HKA00000186299-001 Revision: B
Action
Measure the level of the IRT 710 linear rails at
different locations of the IRT 710. Measurements
should be made on both sides of each section.
Tip
Divide the track into two parts.
Make sure that the side surface of the rail at the
first, middle, and end (Example points: 1, 3, 2) are
on the same straight line. Then secure the track.
Then make sure that the straightness of the half
in one part (Example points: 1, 4, 3) is consistent.
By analogy (Example points: 1, 5, 4), adjust all
the side surfaces to the same straight line.
1
5
4
3
xx2000002601
© Copyright 2023 ABB. All rights reserved.
3 Installation and commissioning
3.4.7.3 Geometric alignment of track motion IRT 710
Note/Illustration
The magnetic base attached to the
reflector must be in contact with
the rail upper surface or side sur-
face.
See the contact surfaces in red on
the picture below:
xx2200000797
2
Continued
A Reflector & Magnetic block
B Linear Rail
C Levelling Screw
Continues on next page
135
Advertisement
Table of Contents
