ABB IRT 710 Product Manual page 317

6
7
8
Refitting the track cover
1
Concluding procedure
1
Product manual - IRT 710
3HKA00000186299-001 Revision: B
Action
Refit the fixed chain end with cables to the car-
riage and secure with screws.
Fix the cables with straps on the cable chain ac-
cording to the photo taken before the replacement.
Run a few strokes in jogging mode and check that
the chain is gliding properly upon itself and is
correctly adjusted sideways.
Action
Refit the cover and secure with the screws.
Action
DANGER
Make sure all safety requirements are met when
performing the first test run. See
may cause injury or damage on page
© Copyright 2023 ABB. All rights reserved.
5.4.2.5 Replacing the fixed chain end
Note
xx2200000888
Screws: ISO 4762 M6x20 Class 8.8
(4 pcs)
Washers: BN 792 M6 Washer (4
pcs)
Tightening torque: 10 Nm
Note
xx2200000616
Screws: ISO 7380-2 M6x12 Class 10.9 (4
pcs)
Tightening torque: 8 Nm
Note
First test run
29.
5 Repair
Continued
317