Pin Calibration - ABB IRT 710 Product Manual

6.5 Pin calibration

Location of calibration tool
The calibration tool is mounted on the track motion as shown in the figure.
xx2200001158
Required equipment
Equipment etc.
Calibration tool
Calibration tool, mirrored
Cleaning agent
Calibrating
Use this procedure to perform fine calibration.
1
Product manual - IRT 710
3HKA00000186299-001 Revision: B
Action
WARNING
Make sure no persons are on the track motion
when the carriage is in motion. Also make sure
that the track motion's cover plates are free from
loose objects, otherwise they can get trapped
between the carriage and the plates.
© Copyright 2023 ABB. All rights reserved.
Article number Note
3HAC042466-001 Attachment screws 9DA183-52
(M10x35), 2 pcs, required. Not in-
cluded with the calibration tool.
3HAC042467-001 Attachment screw 9DA183-52
(M10x35), 1 pc, required. Not in-
cluded with the calibration tool.
- Isopropanol
Note/Illustration
6 Calibration
6.5 Pin calibration
Continues on next page
357