Table of Contents
Advertisement
Routines in the calibration procedure
The following routines are available in the Axis Calibration procedure, given at the
beginning of the procedure on the FlexPendant.
Fine calibration routine
Choose this routine to calibrate the track when there are no tools, process cabling
or equipment fitted to the track.
Reference calibration routine
Choose this routine to create reference values and to calibrate the robot when the
robot is dressed with tools, process cabling or other equipment.
If calibrating the robot with reference calibration there must be reference values
created before repair is made to the robot, if values are not already available.
Creating new values requires possibility to move the robot. The reference values
contain positions of all axes, torque of axes and technical data about the tool
installed. A benefit with reference calibration is that the current state of the robot
is stored and not the state when the robot left the ABB factory. The reference value
will be named according to tool name, date etc.
Follow the instructions given in the reference calibration routine on the FlexPendant
to create reference values.
When reference calibration is performed, the robot is restored to the status given
by the reference values.
Update revolution counters
Choose this routine to make a rough calibration of each track carriage by updating
the revolution counter for each carriage, using the FlexPendant.
Validation
In the mentioned routines, it is also possible to validate the calibration data.
Product manual - IRT 710
3HKA00000186299-001 Revision: B
Note
When calibrating the robot with the reference calibration routine, the robot must
be dressed with the same tools, process cabling and any other equipment as
when the reference values were created.
© Copyright 2023 ABB. All rights reserved.
6 Calibration
6.4.1 Description of Axis Calibration
Continued
347
Advertisement
Table of Contents
