ABB IRT 710 Product Manual page 218

4 Maintenance
4.6.3 Replenishing oil, cam roller unit
Continued
Replenishing oil into the cam roller unit
Use this procedure to replenish the cam roller unit with oil.
Replenishing oil to cam roller unit
1
2
3
Concluding procedure
1
218
Action
WARNING
Overfilling of lubricant can lead to internal
over-pressure which in turn may:
• damage seals and gaskets
• completely press out seals and
gaskets
• prevent the roller from moving freely.
Replenish the cam roller unit with oil to
overflowing state.
Note
Confirm that the color of the flowing out
grease is fresh yellow.
If the grease is black, keep filling it until all
the black grease is completely overflowed
and yellow grease appears.
Clean the excess oil on the outside of the
cam roller.
Action
DANGER
Make sure all safety requirements are met when
performing the first test run. See
may cause injury or damage on page
© Copyright 2023 ABB. All rights reserved.
Note
Note
First test run
29.
3HKA00000186299-001 Revision: B
Product manual - IRT 710