ABB IRT 710 Product Manual page 237

5
6
Refitting the 110 cam roller unit
Use this procedure to refit the cam roller unit.
Refitting the 110 cam roller unit
1
Product manual - IRT 710
3HKA00000186299-001 Revision: B
Action
Remove the flange plate with its screws.
Pull the cam roller unit out.
Action
Fully lubricate and clean the cam roller unit
before install it to the carriage.
Tip
During the operation, watch the seals at
the ball bearing block: when you see the
grease pouring out, you have applied
enough grease.
© Copyright 2023 ABB. All rights reserved.
5.2.2 Replacing the cam roller units
Note
xx2200000810
xx2200000811
Note
Use Shell Retinax LX2.
Continues on next page
5 Repair
Continued
237