ABB IRT 710 Product Manual page 227

3
4
5
6
7
Product manual - IRT 710
3HKA00000186299-001 Revision: B
Action
Insert the motor to the gearbox carefully
with a clearly "Ka-ta" sound.
Refit the motor with four screws and
washers without fully tightened.
If required, use the extension 300 mm for
bits 1/2".
Tip
The bracket should form a 90° angle with
the motor connector in anti-clockwise dir-
ection from the motor side.
Lock the motor and gearbox by tighten the
locking screw.
Tighten the four screws from motor to
gearbox.
Loose the locking screw and retighten it
according to the tightening torque.
© Copyright 2023 ABB. All rights reserved.
5.2.1 Replacing the motor and gearbox
Note
xx2200000619
Screws: ISO 4762 M8x30 Class 12.9 (4 pcs)
Washers: BN 792 M8 Washer (4 pcs)
xx2200001190
Tightening torque: 43 Nm
xx2200001190
Tightening torque: 79 Nm.
Continues on next page
5 Repair
Continued
227