ABB IRT 710 Product Manual page 333

Refitting the fixed chain end
1
2
3
4
5
6
7
8
Product manual - IRT 710
3HKA00000186299-001 Revision: B
Action
Note
If any part of the cable chain tray has been re-
moved, use Loctite 243 when refitting parts. Also
note that the NYLOC nuts can only be used once.
Refit the fixed chain end with bracket to the cable
chain.
Note
Be careful with the cables routing.
Refit the cable chain link besides the fixed chain
end.
Refit the plastic link bars.
Pull the cables from outer side and route the
cable.
Refit the fixed chain end with cables to the car-
riage and secure with screws.
Fix the cables with straps on the cable chain ac-
cording to the photo taken before the replacement.
Run a few strokes in jogging mode and check that
the chain is gliding properly upon itself and is
correctly adjusted sideways.
© Copyright 2023 ABB. All rights reserved.
5.4.2.6 Replacing the cables in cable chain
Note
Replacing the inner cable chain link
on page 295
Replacing the outer cable chain
link on page 288
xx2200000888
Screws: ISO 4762 M6x20 Class 8.8
(4 pcs)
Washers: BN 792 M6 Washer (4
pcs)
Tightening torque: 10 Nm
Continues on next page
5 Repair
Continued
333