ABB IRT 710 Product Manual page 316

5 Repair
5.4.2.5 Replacing the fixed chain end
Continued
6
7
8
Refitting the fixed chain end
Use this procedure to refit the fixed chain end.
Refitting the fixed chain end
1
2
3
4
5
Continues on next page
316
Action
Remove the plastic link bars.
Tip
If needed, pull the cables out a little from inner
side to make more space.
Remove the cable chain link besides the fixed
chain end.
Remove the fixed chain end.
Action
Note
If any part of the cable chain tray has been re-
moved, use Loctite 243 when refitting parts. Also
note that the NYLOC nuts can only be used once.
Refit the fixed chain end with bracket to the cable
chain.
Note
Be careful with the cables routing.
Refit the cable chain link besides the fixed chain
end.
Refit the plastic link bars.
Pull the cables from outer side and route the
cable.
© Copyright 2023 ABB. All rights reserved.
Note
Replacing the inner cable chain link
on page 295
Replacing the outer cable chain
link on page 288
Note
Replacing the inner cable chain link
on page 295
Replacing the outer cable chain
link on page 288
Product manual - IRT 710
3HKA00000186299-001 Revision: B