ABB IRT 710 Product Manual page 256

5 Repair
5.2.4 Replacing the lubrication parts
Continued
3
Concluding procedure
1
Replacing the Y fitting
Removing the Y fitting
Use this procedure to remove the Y fitting.
Preparations before removing the Y fitting
1
2
3
Removing the Y fitting
1
Continues on next page
256
Action
Check that the lubrication system can work
normally.
Action
DANGER
Make sure all safety requirements are met when
performing the first test run. See
may cause injury or damage on page
Action
If there is no enough space for the maintenance
work, clean the surroundings.
If there is any robot on the track, jog it to the lift-
ing/transportation position.
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the product, before entering the safeguarded
space.
Action
Disconnect the tubes.
© Copyright 2023 ABB. All rights reserved.
Note
Note
First test run
29.
Note
Note
3HKA00000186299-001 Revision: B
Product manual - IRT 710