ABB IRT 710 Product Manual page 325

12
13
14
Removing the cables in cable chain
1
2
3
4
Product manual - IRT 710
3HKA00000186299-001 Revision: B
Action
Remove the screws locking the movable chain
end to the bracket.
Remove the cable chain link besides the movable
chain end.
Remove the movable chain end.
Action
Move the carriage as far away as enough on the
movement position direction to make enough
space.
Pull the cables from inner side on the fixed chain
end opening to lay the cable chain flat.
Find the cable you need to replace.
If needed, flip the cable chain over to make the
cable that need to replace is on the upper side.
Tip
Pull out all cables from the cable drawer and take
the movable chain end part of the cable chain to
flip the cable chain over.
© Copyright 2023 ABB. All rights reserved.
5.4.2.6 Replacing the cables in cable chain
Note
xx2200000885
Replacing the inner cable chain link
on page 295
Replacing the outer cable chain
link on page 288
Note
xx2200000896
Continues on next page
5 Repair
Continued
325