ABB IRT 710 Product Manual page 165

Harness outlet - One carriage with even sections
The harness should go out from the outlet on the (N/2 +1) section of the track.
Without external cable chain
With external cable chain on the rack side of the track
External cable chain
With external cable chain on the non-rack side of the track
External cable chain
xx2300001400
Harness outlet - Two carriages with odd sections
The harness of both carriages should go out from the outlet on the central section
of the track.
Product manual - IRT 710
3HKA00000186299-001 Revision: B
Harness outlet
Note
If the track is used for spot welding under this circumstance, it is recommended
to thread the two carriages' cables from two different directions of the outlet.
Otherwise the replacement of the harness will be very difficult due to the
constriction of the space.
© Copyright 2023 ABB. All rights reserved.
3 Installation and commissioning
3.5.10 Harness outlet
Continues on next page
Continued
165