ABB IRT 710 Product Manual page 138

3 Installation and commissioning
3.4.7.3 Geometric alignment of track motion IRT 710
Continued
8
9
10
138
Action
Check the rails alignment according to
alignment in different directions on page
Release the carriage brake and push the carriage
manually along.
If the linear rails are correctly aligned, you should
sense no " step " while passing the rail junction
points. When the alignment is correct, tighten the
screws one by one, after applying Loctite 243 on
its thread.
Use a brush to lubricate the linear rails.
Re-assemble all the cover support brackets and
covers, if necessary.
© Copyright 2023 ABB. All rights reserved.
Note/Illustration
Track
133.
Product manual - IRT 710
3HKA00000186299-001 Revision: B