Table of Contents
Advertisement
3
4
5
6
7
Product manual - IRT 710
3HKA00000186299-001 Revision: B
Action
Lubricate the scraper kit with an oil gun
before install it to the carriage.
Tip
During the operation, check the guide rail:
when you see the grease, you have applied
enough grease.
Refit the scraper kit to the carriage.
Refit the screws and washers without fully
tighten.
Check that the gap between the scraper
and rectangular rail is 0.04 mm - 0.06 mm
with a feeler gauge.
Secure the screws with fully tighten.
© Copyright 2023 ABB. All rights reserved.
5.2.3 Replacing the scraper parts
Note
xx2200000817
Screws: ISO 4762 M8x30 Class 12.9 (3 pcs)
Washers: BN 792 M8 Washer (3 pcs)
Tightening torque: 43 Nm
xx2300001004
Continues on next page
5 Repair
Continued
247
Advertisement
Table of Contents
