ABB IRT 710 Product Manual page 254

5 Repair
5.2.4 Replacing the lubrication parts
Continued
Refitting the grease detection sensor
Use this procedure to refit the grease detection sensor.
Refitting the grease detection sensor
1
2
3
Concluding procedure
1
Replacing the distributor
Removing the distributor
Use this procedure to remove the distributor.
Preparations before removing the distributor
1
2
Continues on next page
254
Action
Refit the sensor and tighten with the screw
.
Note
Pay attention to the position of the sensor
on the bracket.
xx2200000826
Connect the connector:
• sensor
Check that the lubrication system can work
normally.
Action
DANGER
Make sure all safety requirements are met when
performing the first test run. See
may cause injury or damage on page
Action
If there is no enough space for the maintenance
work, clean the surroundings.
If there is any robot on the track, jog it to the lift-
ing/transportation position.
© Copyright 2023 ABB. All rights reserved.
Note
xx2200000822
Note
First test run
29.
Note
3HKA00000186299-001 Revision: B
Product manual - IRT 710