ABB IRT 710 Product Manual page 137

5
6
7
Product manual - IRT 710
3HKA00000186299-001 Revision: B
Action
Use the ABB levelling tool 3HAW107700360 to
adjust the levelling screws until all the measured
points, on both sides of the IRT 710, are at the
same level.
If the base plate is used under the track, weld the
adjustment plate to the base plate.
Do a fine adjustment of the linear rails in both
lateral and transverse.
The planarity tolerance is 0.1mm/m, in lateral and
transverse.
© Copyright 2023 ABB. All rights reserved.
3 Installation and commissioning
3.4.7.3 Geometric alignment of track motion IRT 710
Note/Illustration
It is recommended to use one of
the highest points of the IRT 710
as reference: It is easier to bring
the crossmember to a higher level
rather than to bring it to a lower
level.
xx2200001204
xx2200001205
xx2200001206
A
Continued
Fine adjustment screw
Continues on next page
A
137