YASKAWA GA700 Series Technical Manual page 992

◼ Se t the Trigger
The procedure in this section shows how to set the trigger for data logging.
Note: This setting is displayed only when short-term data log is selected for the data log
type.
1. Push (Home) to show the HOME screen.
Note:  When the drive is in HOME Mode, the screen shows [Home] in the upper right-
hand corner of the screen.
 If the screen does not show [Home] for
to show [Home].
2. Push (Menu).
3. Push or
4. Push or
5. Push or
6. Push or
7. Push or
Note: There are no detection width and detection time settings for the analog trigger in the
data log function. If variations in the analog signal become a problem, select the digital
trigger and use
conditions for the comparator function with
to select [Diagnostic Tools], then push
to select [Data Logger], then push
to select [Log Trigger], then push
to select [Trigger Type Selection], then push
to select the type of trigger, then push
o5-16 = 66/67 [Digital Trigger Object = Comparator 1/2].
, push (Back), and then push
.
(Setup).
.
.
.
H2-20 to H2-32 .
D ocu ment No. E ZZ024048<1>
P r epared in October, 2021
Set the
8 / 19