Repair; Magnemover Lite Repair Procedures - Rockwell Automation MagneMotion MagneMover LITE Original Instructions Manual

Repair

If a component of the MagneMover LITE transport system malfunctions, see
on page 371 in this manual for diagnostic procedures. If these procedures are not adequate to
determine the source of the problem, see
page 382. Once the failed unit has been identified, a replacement unit can be ordered and
installed as directed in
NOTE: The components of the MagneMover LITE transport system are designed for easy
replacement. Motors, controllers, and other modules do not contain any user service-
able parts.
NOTICE
Component
MagneMover LITE Trans-
port System
Puck
Power Supply
MagneMover LITE User Manual
Contact Rockwell Automation Technical Support on
Installation on page 237.
Only a qualified service representative can service the com-
ponents of the MagneMover LITE transport system. Any
attempt to open the transport system modules by anyone
other than a qualified service representative voids the war-
ranty.
Table 7-10: MagneMover LITE Repair Procedures
Replace RS-422 Motors
Program RS-422 Motors
Replace RS-422 Motors with Ethernet Motors
Replace Ethernet Motors
Program Ethernet Motors
Replace Motor Rails
Replace Switch Rails
Separating Magnet Arrays
Replace Pucks
Replace Glide Puck Wear Surfaces
Replace Tandem Glide Puck Wear Surfaces
Replace Wheeled Puck Wear Surfaces, 4-Wheel Pucks
Replace Wheeled Puck Wear Surfaces, 2-Wheel Pucks
Replace Tandem Wheeled Puck Wear Surfaces
Replace MM LITE Power Supply Fuses
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
Maintenance Action
Maintenance
Repair
Troubleshooting
Page #
385
387
388
391
393
394
396
398
399
402
406
412
416
419
425
383