Install The Precision Locators On The Stands; Install The Precision Locator Assemblies; Install The Motors - Rockwell Automation MagneMotion MagneMover LITE Original Instructions Manual

Installation
Option Installation

Install the Precision Locators on the Stands

The precision locators are installed on the stands before installing the stands to provide ease of
assembly. The precision locators can be removed or installed on the stands once the stand is
installed in the transport system, however it is more difficult to access the mounting screws
for the locator.
1. Install the pneumatic fittings on the precision locator cylinder using Teflon
2. Install each precision locator on the stand and secure using four M6 x 25 mm screws
then tighten to 4.5 N•m [40 in•lb] with a 5 mm Hex wrench.

Install the Precision Locator Assemblies

The stands are installed loosely to allow final positioning with the equipment accessing the
pallet.
1. Remove the back plate from the stand by removing the M6 x 12 mm screws securing it
and store the screws for reuse.
2. Install the precision locator stand.
Mounting the Standard Precision Locator Stand (see
A. Install one M8 T-nut in the top channel of the beam at the approximate location
for each precision locator stand rib. T-nuts must be inserted so that the spring
steel tabs are facing toward the beam, then rotated clockwise into place).
B. Position the locator stand on the beam and aligned to the T-nuts, install an M8
x 30 mm bolt and M8 split lock washer for each rib and finger-tighten.
Mounting the Alternate Precision Locator Stand (see
A. Position the locator stand onto the locating pins on the custom fixturing.
B. Install an M8 x 30 mm bolt and M8 split lock washer for each rib and fin-
ger-tighten.

Install the Motors

Once the motors are installed and properly positioned, the precision locator can be secured in
its final position.
1. Install the adjustable motor mounts on the motor (see
Motors and
2. Install the motor (see
Secure Motors and Switches on page
The Loctite must cure for 2 hours at 22° C [72° F] before using the transport system.
298
Switches).
Mounting Motors and Switches on page 256
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
Figure
Figure
Installing Motor Mounts on
258).
™
tape.
5-43)
5-44)
and Align and
MagneMotion