Installation Overview - Magnemotion Precision Rails - Rockwell Automation MagneMotion MagneMover LITE Original Instructions Manual

Installation
Transport System Installation
8. Make all communication, network, and power connections (see
and Electronics on page 266
9. Assemble the next section of the system following
it to the previously installed section verifying that both sections are in the same plane
and level to each other.
10. Continue assembling and installing sections until the system is complete.
11. Install the vehicles (pucks) on the system (see
page 276).
NOTE: Install vehicles (pucks) on captive closed loop systems before closing the
12. Install cable chase covers once all wiring is complete and has been tested (see
ing Cable Chase Covers on page
13. Install the user-supplied electrical power and communication connections (see
ties Connections on page
14. Create the Node Controller Configuration File (see
15. Power up the system and check all operating features, safety features, and connections
(see System Check-out on page
page 310).
Installation Overview – MagneMotion Precision Rails
The following sequence provides an overview of the installation of the precision rail option on
a MagneMover LITE transport system using railless motors.
NOTICE
1. Assemble a complete section of the system stand, including the stand and beam (see
Assembling Beams on page 247
2. Adjust the feet on the stand section to make sure that it is flat and level (see
the MagneMover LITE on page
3. Secure the stand section to the floor or other equipment as required (see
Transport System on page
244
and
loop to eliminate the need to remove a guide rail.
302).
309) and install software (see
Make sure that the stand system where the MagneMover
LITE motors are mounted is properly grounded to safety
ground (earth).
251).
252).
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
Network Connections on page
Step 1
Installing Magnet Arrays/Pucks on
278).
Software on page
and Installing System Legs on page
Connecting Motors
302).
through Step 8 and connect
Install-
Facili-
307).
System Power-up on
248).
Leveling
Securing the
MagneMotion