Rockwell Automation MagneMotion MagneMover LITE Original Instructions Manual page 312

Installation
Check-out and Power-up
11. When using Ethernet motors:
A. Create a MICS file (see
B. Upload the MICS file to all node controllers (see the Node Controller Interface
User Manual, MMI-UM001).
C. Cycle logic power to the motors to force the motors to request their network
provisioning.
12. Program the motors. See the Node Controller Interface User Manual, MMI-UM001,
for details.
Once programming is complete, any short flipper switches start the flipper homing
process (the flipper moves in and out – a series of slow moves then a series of rapid
moves).
13. Review the log files for each node controller to make sure that the system has been
programmed and configured properly (see the Node Controller Interface User Man-
ual, MMI-UM001).
312
Ethernet Motor MICS File on page
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
97).
MagneMotion