Installing Motor Power Cables; Power Connections - Rockwell Automation MagneMotion MagneMover LITE Original Instructions Manual

Hide thumbs Also See for MagneMotion MagneMover LITE:
Table of Contents

Advertisement

Installation
Transport System Installation

Installing Motor Power Cables

See
Figure 4-56 on page 208
motors and switches and
power supply. See
Figure 5-24
shows the power connections being made to the bottom of the motor. The power
connections are the same for motors that use RS-422 communication and for motors that use
Ethernet communication.
Power Bus
End Cap
NOTICE
The AC power connections are made later (see
trical Wiring on page 86
page 206
when connecting the power cables to the motors to make sure that each chain of
motors does not exceed the rated output of the MM LITE power supply (600 W). MagneMo-
tion recommends that a maximum of 10 motors be connected to J1 or J2 on the power supply
at one time (20 motors per power supply).
274
through
Figure 4-59
Figure 4-60
for the power connection locations on the MM LITE
Figure 5-18
and
Figure 5-19
Motor Power Connector
Power Bus Cable
T-Splitter Power Cable
Figure 5-24: Power Connections
If a user-supplied power supply is used, it must be
NRTL/ATL approved.
to make sure that all power wiring is properly sized. See
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
for the power connection locations on the
for simplified diagrams of the wiring.
Power Cable
Ground
Node Controller
(NC-12 Shown)
Facilities Connections on page
J2
0W
C 30
36 VD
V+
N
UL SIO
C 30
0W
PR OP
V+
36 VD
C
J1
LO GI
V-
N
UL SIO
RN
V+
RE TU
PR OP
D
V+
C
GN
LO GI
V-
RN
RE TU
LE
EN AB
T)
OU
D
J4 DC
R PIN
GN
AL FO
MA NU
(S EE
J3
MM LITE
Power Supply
302). See
Elec-
Table 4-9 on
MagneMotion

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MagneMotion MagneMover LITE and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents