Install Pucks - Rockwell Automation MagneMotion MagneMover LITE Original Instructions Manual

Install Pucks

1. Stop all motion on the section of the MagneMover LITE transport system where the
puck is being installed.
2. Remove the inside guide rail from a curve motor.
A. Remove the two M6 x 12 mm screws that secure the V-braces to the guide rail.
B. Remove the two M6 x 10 mm screws that secure the guide rail to the motor.
C. Lift the guide rail off the motor.
3. Install pucks and slide them onto the adjacent motors.
4. Replace the guide rail by reversing
A. When replacing Stainless Steel rails, apply Loctite 243 to the M6 x 10 mm rail
mounting screws and the M6 x 12 mm V-brace screws.
B. Install and tighten the M6 x 10 mm guide rail mounting screws and the M6 x
12 mm V-brace screws to 3.4 N•m [30 in•lb].
The Loctite must cure for 2 hours at 22° C [72° F] before using the transport
system.
5. Return the MM LITE transport system to normal operation.
MagneMover LITE User Manual
Step
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
2.
Maintenance
Repair
401