Rev. D - Rockwell Automation MagneMotion MagneMover LITE Original Instructions Manual

• In Chapter 7,
RS-422
Parts.
Updated the following:
• Updated the Overview Note in this section.
• Updated all figures to show MM LITE G4 motors.
• In the About This Manual
• In Chapter 1,
include the NC-12 node controller. Updated the
to include new Type files and updated the descriptions of existing Type files.
• In Chapter 2, Safety
sonnel Safety
Recycling and Disposal Information
• In Chapter 4, Specifications and Site
exclusion zone, and
specifications
identification. Updated the
• Updated, and moved to
• In Chapter 5,
Updated
• In Chapter 6,
• In Chapter 7,
ing while the system is energized. Updated the
cedure for G4 pucks. Updated the
• In the Appendix, updated the
• Updated the Glossary.

Rev. D

Added the following:
• In Chapter 2, Safety
Rail Option Hazard Locations
• Recycling and Disposal Information
• In Chapter 3, Design
rier on the magnet array or motor to the
tem Options, which includes the
• In Chapter 4, Specifications and Site
the railless motors, the G4.2 and G4.3 pucks, the G4.2 and G4.3 tandem pucks, and the
G4.2 magnet array.
MagneMover LITE User Manual
Maintenance, added procedures for
Motors. Added Node Controller Troubleshooting
chapter, updated the list of
Introduction, updated the
Guidelines, updated all magnet safety warnings and added to
Guidelines. Updated all figures to show current labeling. Updated the
mechanical drawings
for all components to include connector pinouts and corrected connector
environmental
Chapter 7,
Installation, simplified the
Software installation and configuration information.
Operation, updated the
Maintenance, updated the
Transport System
Guidelines, added UL Registration information. Added
Guidelines, added the recommendation to use a low friction bar-
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
Glide Puck Cleaning
Related
Transport System Components Overview
Transport System Software Overview
to include all node controllers.
Requirements, consolidated connector location,
for all components. Updated the
specifications.
Maintenance, the rail adjustment procedure.
network switch mounting
Shutdown procedure.
General Cleaning
Replace Glide Puck Wear Surfaces
Shipping procedures.
Limits.
and Labels for the precision rail components.
for the MagneMover LITE system.
Vehicle Design
Precision Rail and the
Requirements, added
Changes
and Program
and information on Ordering
Documentation.
electrical
information.
procedure to allow clean-
Precision
section. Added Transport Sys-
Precision Locator.
mechanical drawings
to
Per-
pro-
for
23