Rockwell Automation MagneMotion MagneMover LITE Original Instructions Manual page 245

4. Attach cable chase cover brackets to curve motor mounts (see
Cover Brackets on page
5. Attach the motor mounts to all motors (see
Switches on page
6. Install the motors, make sure that the motors are collinear to each other and the tops of
all motors are coplanar to each other and tighten the V-braces (see
Railless Motors on page
NOTE: If motors are installed in a wash-down environment, it must not exceed IP65.
7. Attach the precision rail support post assemblies to the beam (see
Rail Support Posts to the Beam on page
NOTE: Loosely fasten all precision rail hardware (finger-tighten then back off
8. Attach the precision rails to the support posts (see
page 285).
9. Install the vehicles on the system (see
NOTE: Install vehicles (pucks) on captive closed loop systems before closing the
10. Once all components are loosely fastened together, make final adjustments and tighten
(see Align and Secure Rails to Spine Plates on page 288
Support Posts on page
11. Install the power supplies, node controllers, network switches, and cables (see
ing Electronics on page
12. Make all communication, network, and power connections (see
and Electronics on page 266
13. Install cable chase covers once all wiring is complete and has been tested (see
ing Cable Chase Covers on page
14. Install the user-supplied electrical power and communication connections (see
ties Connections on page
15. Create the Node Controller Configuration File (see
16. Power up the system and check all operating features, safety features, and connections
(see System Check-out on page
page 310).
MagneMover LITE User Manual
254).
255).
261).
Make sure that there is sufficient space around the motor mounting surface
for all connectors and for the bend radius of all cables.
one-half turn) to allow for alignment and final adjustments once all compo-
nents within the system have been assembled.
loop to eliminate the need to remove a precision rail.
291).
263).
and
302).
309) and install software (see
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
Installing Motor Mounts on Motors and
284).
Attach Rails to Spine Plates on
Replace Precision Rail Vehicles on page
Network Connections on page
278).
Software on page
Installation
Transport System Installation
Installing Cable Chase
Align and Secure
Attach Precision
428).
and Secure Spine Plates to
Install-
Connecting Motors
302).
Install-
Facili-
307).
System Power-up on
245