Shipping Components - Rockwell Automation MagneMotion MagneMover LITE Original Instructions Manual

Maintenance
Shipping
kg
1. Turn off and disconnect all electrical and pneumatic power as described in
on page
2. Disconnect all communication connections as described in
3. Make sure that the system or component has been properly decontaminated following
the decontamination procedures for the facility. Follow all facility, local, and national
procedures for the disposal of any hazardous materials.
4. When shipping individual components, remove all components to be shipped (see
Transport System Installation on page 241
components) and see
When shipping systems, see

Shipping Components

Each component must be wrapped, bagged, and packed following standard packing proce-
dures.
1. If possible, use the box that the component was originally shipped in. Set the compo-
nent into the box and secure using the packing material in the box. If the original ship-
ping box is not available, package the component appropriately to prevent damage and
secure in the shipping box.
2. Make sure that the container is properly labeled (This End Up, Caution – Heavy, and
so on) and all shipping documents are attached to the outside of the container.
3. When shipping to MagneMotion, make sure that the RMA number is clearly visible on
the outside of the container.
460
LIFTING HAZARD
The MagneMover LITE components can weigh as much as
7.3 kg [16.1 lb].
Use proper techniques for lifting and safety toe shoes when
moving any MagneMover LITE components.
344.
Shipping Components on page
Shipping Systems or System Sections on page
MAGNETIC FIELD HAZARD
When shipping pucks or magnet arrays, make sure
that the shipping container properly isolates the mag-
nets and identifies the Magnetic Field Hazard.
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
Shutdown on page
and reverse the sequence to remove the
460.
Shutdown
344.
461.
MagneMotion