Shipping Systems Or System Sections - Rockwell Automation MagneMotion MagneMover LITE Original Instructions Manual

Shipping Systems or System Sections

1. Bolt the feet to the bottom of the crate.
2. Install brackets to secure the leg outriggers to the bottom of the crate.
3. Make sure that all hardware on the system is properly secured.
4. Secure any loose wires to the system frame with plastic shipping film.
5. Secure any vehicles (pucks) on the system by moving them to one section of the sys-
tem and wrap them and the motors they are on in plastic shipping film.
6. Make sure that the sides of the crate are padded and secure the system in place once
they are attached to the crate.
7. Secure the sides and top of the crate to the crate.
8. Make sure that the crate is properly labeled (This End Up, Caution – Heavy, and so on)
and all shipping documents are attached to the outside of the crate.
9. Add tip indicators, shock indicators, moisture indicators, and so on, to the outside of
the shipping container as desired to verify proper handling during shipment.
10. When shipping to MagneMotion, make sure that the RMA number is clearly visible on
the outside of the crate.
MagneMover LITE User Manual
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
Maintenance
Shipping
461