Rev. C - Rockwell Automation MagneMotion MagneMover LITE Original Instructions Manual

Changes
• In Chapter 6,
• In Chapter 7,
Added packing and shipping procedures
• Added an
system limits.
Updated the following:
• Trademark and copyright information.
• All figures show the new frame mounting system.
• Changed all MagneMover LITE abbreviations from "ML" to "MM LITE".
• Corrected the names of all referenced MagneMotion
• In Chapter 1,
the system specification.
• In Chapter 4, Specifications and Site
and updated
• In Chapter 5,
tion procedures. Updated the
• In Chapter 6,
Updated the descriptions for the standard node controller
• Updated, and moved to
Updated the
• Updated the Glossary.
Removed the following:
• Removed all references to "physical" and "virtual" components. Removed unsup-
ported RS-232 communication information. Removed hot plug warnings.

Rev. C

Added the following:
• Added information on the NC-12 node controller.
• In Chapter 1,
• In Chapter 2, Safety
custom vehicles with user-supplied rails requires all vehicles are grounded to the
guideway.
• In Chapter 3, Design
port systems using MM LITE railless motors.
• In Chapter 4, Specifications and Site
Types and added
magnet array, and NC-12 node controller.
• In Chapter 6,
tion.
22
Operation, added a description of
Maintenance, added
Appendix with information about additional documentation and transport
Introduction, updated the descriptions of all
service and exclusion zone
Installation, updated the unpacking,
Check-out and Power-up
Operation, updated the information on the
Chapter 7,
fuse replacement procedures.
Introduction, added motor programming to the
Guidelines, added
Guidelines, added
mechanical drawings
Operation, added new information to the existing
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
motor operation.
spray cleaning and puck maintenance
and information.
®
manuals.
Requirements, updated all
information.
installation overview,
procedure.
Synchronization
Maintenance, the puck replacement
Symbol Identification. Added notice that using
Transport System Design
Requirements, added an overview of
for the MM LITE G4 motors, switches, pucks,
procedures.
system software. Updated
mechanical drawings
and installa-
option.
E-stop and interlock.
procedure.
Getting Started section.
for designing trans-
Motor
motor operation
MagneMotion
sec-