User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Table 8-2.
Broadcast Storm Recovery Thresholds
Link Speed
10M
100M
1000M
Format
Mode
storm-control flowcontrol
This command enables 802.3x flow control for the switch.
Note: 802.3x flow control works by pausing a port when the port becomes oversubscribed and
dropping all traffic for small bursts of time during the congestion condition. This can lead to high-
priority and/or network control traffic loss.
Note: This command only applies to full-duplex mode ports.
Default
Format
Mode
no storm-control flowcontrol
This command disables 802.3x flow control for the switch.
Note: This command only applies to full-duplex mode ports.
Format
Mode
show mac-address-table multicast
This command displays the Multicast Forwarding Database (MFDB) information. If the command
is entered with no parameter, the entire table is displayed. This is the same as entering the optional
all parameter. The user can display the table entry for one MAC Address by specifying the MAC
address as an optional parameter.
Format
Mode
Switching Commands
High
20
5
5
no storm-control broadcast
Global Config
disabled
storm-control flowcontrol
Global Config
no storm-control flowcontrol
Global Config
show mac-address-table multicast <macaddr | all>
Privileged EXEC
202-10102-01, May 2005
Low
10
2
2
8-45