Storm-Control Flowcontrol; Show Storm-Control - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

9.2.2 storm-control flowcontrol

This command enables 802.3x flow control for the switch and only applies to full-duplex
mode ports.
Note: 802.3x flow control works by pausing a port when the port becomes
Default
Format
Mode
9.2.2.1 no storm-control flowcontrol
This command disables 802.3x flow control for the switch.
Note: This command only applies to full-duplex mode ports.
Format
Mode

9.2.3 show storm-control

This command displays switch configuration information.
Format
Mode
Broadcast Storm
Recovery Mode
802.3x Flow
Control Mode
9-6
oversubscribed and dropping all traffic for small bursts of time during the
congestion condition. This can lead to high-priority and/or network control
traffic loss.
disabled
storm-control flowcontrol
Global Config
no storm-control flowcontrol
Global Config
show storm-control
Privileged EXEC
May be enabled or disabled. The factory default is disabled.
May be enabled or disabled. The factory default is disabled.
v1.0, March 2006
Port-Based Traffic Control Commands