New Holland T8010 Manual page 1694

STEP 88
The display reads FSUS CAL. Press the PROG key
to automatically start the calibration process. The
Suspended Axle Switch lamp will flash on and off.
STEP 89
The display numbers (nnnn) will change as the
calibration is in progress. This display is the front axle
position sensor output voltage.
Section 55 - Electrical System, Controller - Chapter 6
RD06A080
RD05G030
55-6-49
STEP 90
When the calibration is completed the display will
show FSUS Cal Done.
NOTE: If the PROG key is pressed during the
calibration the display will read CAL ABORTED.
STEP 91
If the calibration process fails the display will read
CAL FAILED. The Suspended Axle Switch lamp will
turn off. If the CAL FAILED message appears press
the PROG key to access the Error Message Display.
RD05G026
RD05G043
RD05G044