New Holland T8010 Manual page 1731

STEP 9
Place one of the load bearings from CAS2577 under
the rear cab raising bracket. Insert one of the longer
threaded rods from the kit through the rear cab
raising bracket, the load bearing, and the through
hole in the cab suppor t bracket. Thread the rod
through the raising bracket until the threads contact
the load bearing.
STEP 10
Inser t the locking pin through the bottom of the
threaded rod. Tighten the nut on the bolt through the
raising bracket and the cab side panel.
NOTE: For photographic purposes, the locking pin
shown is on the left rear side of the cab.
STEP 11
Install the left rear cab raising bracket CAS2577-2
into the left rear cab support tube. Repeat Steps 7
through 9 on the left rear side of the cab.
Section 90 - Cab, Hood, Seat - Chapter 2
77-23
77-36X
90-2-6
STEP 12
Install the upper cab raising bracket (1) from
CAS2577 Cab Raising Bracket Kit into the left front
cab support tube. Install CAS2577-3 lower raising
plate (2) on the front cab mounting bracket, using two
of the bolts from the kit. Place a load bearing on top
of the lower raising plate and insert one of the shorter
threaded rods through the upper raising bracket.
Thread the rod through the raising bracket until the
threads contact the load bearing. Insert the locking
pin through the bottom of the threaded rod. Repeat
this procedure on the opposite side of the cab.
NOTE: For easier installation of the right hand lower
raising plate (2), raise the front left side up a few
inches.
STEP 13
Turn in the four threaded rods on the cab raising
brackets in equal amounts to evenly lift the cab.
NOTE: Monitor all lines when raising or lowering the
cab to prevent breakage or bending of lines.
1
2
76-0A