New Holland T8010 Manual page 1704

Hide thumbs Also See for T8010:

Table of Contents

Aux Adjust Menu

With AUX ADJUST on the display, press the PROG

Press the INCR or DECR key to select the remote

section (1 through 5) and the extend or retract circuit

for that section.

NOTE: Only valve sections with a valid lever range

and no faults will be broadcast (over the Tractor Data

Bus) from the armrest controller will be listed in this

Section 55 - Electrical System, Controller - Chapter 6

Press the PROG key for the section circuit of your

choice. The current valve setting, which will be a

number between -40 to +40 will be displayed. If the

va lue di sp layed is in cr eas ed , the fl ow c ur ve

associated with that valve will be shifted to the left.

This res ul ts in a higher flow for a given flow

potentiometer setting for that flow direction. If the

value is decreased, the flow curve associated with

that valve will be shifted to the right. This results in a

lower flow for a given flow potentiometer setting for

that direction. As the displayed value is changed, the

shift in the flow curve will take effect immediately. The

range of adjustment is -40 to +40, with 0 having no

effect on the flow curve.

Pr es s th e I NCR o r DEC R key to in cr ea se or

decrease the number. Each time the INCR or DECR

key is pressed, the flow will change 0.2 to 0.6 GPM

(0.7 to 2.2 LPM).

Chapters

Table of Contents

T8020 T8030 T8040