New Holland T8010 Manual page 1692

STEP 81
Press the DECR key multiple times until SETUP
FSUS is displayed. Press the PROG key to enter the
Menu.
STEP 82
The display will read NO FSUS, or YES FSUS. To
change status press INCR or DECR key. When the
status is correct press PROG key.
Section 55 - Electrical System, Controller - Chapter 6
RD05G012
RD05G037
RD05G035
55-6-47
STEP 83
The display will read DONE. After 1 second the
display exits this menu.
Front Suspension Menus
The following menus are available for the Front
Suspension.
1. FSUS CAL - This menu allows the user to
Calibrate the Front Suspended axle.
2. FSUS DEMO - This menu can only be accessed
when the Electronic Service Tool (EST) is in use
on the tractor. It allows the user to switch the
Front Suspended Axle ON or OFF especially at
speeds greater than 12 KMH.
3. FSUS MANUAL - This menu allows the operator
to manually operate the Front Suspension. The
axle may be raised or lowered when the tractor is
stationary.
4. EXIT FSUS- This menu entry will exit the Front
Suspension Menus.
RD05G041