Front Suspension Demo
The menu is accessed through the Trans Setup
Menu.
NOTE: This menu will only work when the Electronic
Service Tool is in use.
STEP 93
Start the engine.
Push and hold the PROG key for two seconds within
the first ten seconds after starting the tractor. A short
beep will indicate that the program mode has been
accessed and the display will read CONFIG MENU.
Push the DECR key until the display reads TRANS
and press the PROG key again.
Section 55 - Electrical System, Controller - Chapter 6
RD05G056
RD06A057
55-6-51
STEP 94
When the TRANS VIEW menu is displayed, push the
DECR key.
STEP 95
The display will read TRANS SETUP. Press the
DECR key.
STEP 96
The display will read TRANS FSUS. Press the
PROG key.
RD05F104
RD05F125
RD06A079