New Holland T8010 Manual page 1687

STEP 63
The display will read EVEN CLUTCH. Push the
PROG key and the tractor transmission controller will
automatically run through the Even clutch calibration
procedure.
The display will read *EVEN mA when the Even
clutch calibration is completed. Push the PROG key.
Repeat this procedure to calibrate the C1, C3, C5,
LOW, MID, HIGH, REV and MSTR clutch.
STEP 64
After performing the calibration procedure on all
clutches the display will now read *MSTR mA. Push
the PROG key once.
Section 55 - Electrical System, Controller - Chapter 6
RD05F178
RD05F186
55-6-42
STEP 65
The display will now read EXIT CAL. Push the prog
key once.
STEP 66
The display will now read SHIFT TO PARK. Shift the
transmission control lever into PARK position.
STEP 67
The display will now read EXIT CAL again.
Reduce engine speed to low idle. Turn ignition switch
to OFF position. The calibration will be saved when
the tractor is shutdown.
RD05G017
RD05G018
RD05G017