New Holland T8010 Manual page 1740

Hide thumbs Also See for T8010:

Table of Contents

Install the rear lifting bracket (1) and extension arm

(2). Install the mounting nut (3) (not shown). Make

sure the mounting bracket (1) is fully seated on the

ROPS post. Tighten the nut. Repeat this step and the

previous step on the opposite side of the cab.

NOTE: If side mounted lights were removed, use

care not to pinch the wire harness when installing the

J-hook and lifting bracket.

NOTE: Do not lift the cab until all electrical cables,

hydraulic lines, and mechanical parts needed for cab

removal have been tagged and disconnected.

Remove the cab floor plug. Remove the nut and

washer from the front cab mount bolt. Have an

assistant hold the head of the bolt under the cab.

Repeat this operation on the opposite side of the cab.

Section 90 - Cab, Hood, Seat - Chapter 2

Remove the rear cab mount nut and washer on both

sides of the cab.

Attach a lift hook to the cab lift tool CAS2531.

Chapters

Table of Contents

T8020 T8030 T8040