New Holland T8010 Manual page 1683

STEP 44
The display will read CLTCH CAL. See the Clutch
Calibration Procedure. To see the next setup menu
press the DECR key.
NOTE: The display will go directly to Step 48, GEAR
DEFAULT, unless the Electronic Service Tool (EST)
is in use.
STEP 45
The display will read RESET NVM. To see the next
setup menu press the DECR key.
IMPORTANT: The RESET NVM menu will only
appear when the Electronic Service Tool (EST) is in
use. Do Not enter this menu. Press the DECR key.
STEP 46
The display will read SETUP BKUP ALM. To see the
next setup menu press the DECR key.
IMPORTANT: The SETUP BKUP ALM menu will
only appear when the Electronic Service Tool (EST)
is in use. Do Not enter this menu. Press the DECR
key.
STEP 47
The display will read SETUP FSUS. To see the next
setup menu press the DECR key.
IMPORTANT: The SETUP FSUS menu will only
appear when the Electronic Service Tool (EST) is in
use. To see the next setup menu press the DECR
key.
Section 55 - Electrical System, Controller - Chapter 6
RD05F126
55-6-38
STEP 48
The display will read GEAR DEFAULT. See the Gear
Default Mode in this section. Press DECR key.
STEP 49
The display will read EXIT SETUP. Press PROG key
to exit.
RD05F131