New Holland T8010 Manual page 1715

Hitch Setting Menu
Go to the Hitch Setting menu as shown under Hitch
Setup Main Menu. The Hitch Setting Menu allows
you to set certain performance parameters.
NOTE: Each parameter has a default setting that
would be preferred
conditions.
Press PROG key.
STEP 13
The lower line of the display will read Drop 1. This
will allow you to set the slowest drop rate of the hitch.
The three choices are 12, 16 and 20 second. The
default setting is 12 seconds.
1. Press the INCR or DECR key to scroll through
the selections.
2. Press the PROG key to select your choice of
drop rate. The system will go to the next step.
Section 55 - Electrical System, Controller - Chapter 6
RD06A082
under normal operating
RD06A084
STEP 14
The lower line of the display will read R/D Rate
(raise/drop rate). The top line of the display will show
the present user setting for this (either yes or no). If
Yes is selected, the system will use the drop rate
setting to set the raise rate. If No is selected, the
hitch will raise to the rate specified in Step 12. The
default setting for this step is No.
1. Press the INCR or DECR key to toggle between
Yes and No.
2. Press the PROG key to select your choice. If Yes
is selected, the system will go to Step 13. If No is
selected, the system will go to Step 12.
STEP 15
The lower line of the display will read Raise. This will
allow you to choose the approximate desired time to
fully raise the hitch. There are five choices for this: 2,
4, 6, 8, and 10 seconds. The default time is 2
seconds.
1. Press the INCR or DECR key to change the
selection.
2. Press the PROG key to choose your selection.
The system will go to Step 13 when your choice
is made.
55-6-70
MD05F056
RD06A086