New Holland T8010 Manual page 1707

•
Enable - lever not in neutral during pre-cal check.
•
Quit - During calibration, the lever of valve being
calibrated was moved from neutral, INCR, Decr
or PROG key was pushed.
•
PSI - Feedback signal out of range low or high
during pre-cal check.
•
Cal Time - Pressure takes to long to drop during
settling phase of calibration
•
Cal Halt - Anytime a fault is associated with the
section is detected.
•
Cal Fail - Starting current generates too much
pressure or the commanded current has gone
through its valid range without finding the
threshold.
NOTE: Disconnect any implement from the remote
hydraulic valves before performing the AUX CAL
procedure.
NOTE: Before performing the AUX CAL procedure,
make sure valve spools are moving freely. With the
engine running, cycle each remote hydraulic section
to the extend and retract detente position.
STEP 16
Connect Remote Hydraulic Calibration Tool CAS
2806 to the implement potentiometer connector
(C150M below cab) and the load sensing diagnostic
port on the remote valve.
Section 55 - Electrical System, Controller - Chapter 6
RD02E096
55-6-62
STEP 17
With AUX CAL on the display, Press the PROG key.
STEP 18
The display will read Start Auto Cal. To begin the
automatic calibration press the PROG key.
ATTENTION: If a manual calibration of an individual
Aux section is desired, when the display reads Start
Auto Cal press the DECR key. The display will read
Start Man Cal. This menu will allow you to manually
select the Aux (remote) section that you wish to
calibrate. Press the PROG key.
Press the INCR or DECR key to select the aux
section that you wish to calibrate. Press the PROG
key to calibrate that section.
RD06A129
RD06A171