New Holland T8010 Manual page 1717

Hitch View Menu
The Hitch View Menu allows the user to see different
parameters of the system. It is used to monitor the
hitch system for diagnostic purpose. The tractor
should be running.
STEP 18
Press the PROG key with HITCH VIEW on the
display. Press the INCR or DECR key to scroll
through the menu.
Hitch view menu:
1. RAISE mA
2. LOWER mA
3. PWMR - Pulse width modulation count raise
4. PWML - Pulse width modulation count lower
5. R DRAFT - Software count right load pin
6. L DRAFT - Software count left load pin
7. POS - Hitch feedback position measured in
millivolts
Section 55 - Electrical System, Controller - Chapter 6
RD06A089
55-6-72
STEP 19
Press the PROG key. The display will now read
HITCH VIEW.
Press DECR key to go to HITCH NVM, or to HITCH
EXIT.
STEP 20
Press the PROG key to exit the hitch menus
STEP 21
Cycle the key switch OFF, then ON. Check to see if
there are any fault codes. Erase any fault codes if
they exist.
RD06A089
MD05F063A