New Holland T8010 Manual page 1691

Hide thumbs Also See for T8010:

Table of Contents

Front Suspension Installation

This menu allows the user to install, or remove the

FSUS (Front Suspension).

NOTE: This menu will only work when the Electronic

Service Tool is in use.

Push and hold the PROG key for two seconds within

the first ten seconds after starting the tractor. A short

beep will indicate that the program mode has been

accessed and the display will read CONFIG MENU.

Push the DECR key until the display reads TRANS

and press the PROG key again.

Section 55 - Electrical System, Controller - Chapter 6

When the TRANS VIEW menu is displayed, push the

The display will read TRANS SETUP. Press The

PROG key to enter the Transmission Setup Menus.

Chapters

Table of Contents

T8020 T8030 T8040