New Holland T8010 Manual page 1685

STEP 54
The display will read OIL DEGC. The transmission oil
temp should be between 60 and 105 degrees C (140
to 221 degrees F). Push the PROG key.
NOTE: If the temperature was not in range see Step
55. If the transmission oil temperature was in the
proper range see Step 56.
STEP 55
If the transmission oil temp is below 60 degrees C
the LOW OIL TEMP message will be displayed for 4
seconds. The display will then retur n to the oil
temperature display.
NOTE: If the PROG key is pressed when LOW OIL
TEMP is on display the calibration procedure may be
continued. Calibration at a lower temperature should
only be performed
temperature range cannot be achieved.
NOTE: If the oil temp is above 105 degrees C the
display will read HOT OIL TEMP, if the oil temp is
below 10 degrees C the display will read COLD OIL
TEMP. The display will return to oil temperature
display after 4 seconds.
Section 55 - Electrical System, Controller - Chapter 6
RD05F128
RD05F129
when the recommended
STEP 56
The display will read ENG RPM. Increase the engine
RPM to 1100 to 1300 RPM. Push the PROG key.
NOTE: If the program key is pushed when the RPM
is not in the proper range The display will read CAL
ABORTED. Pushing the PROG key again will display
CAL EXIT. To continue the calibration procedure
push the PROG key.
STEP 57
The display will now read ENG STBLZNG. After
several seconds the display will change.
55-6-40
MD05F072
RD05G016