New Holland T8010 Manual page 1708

STEP 19
The first portion of calibration procedure is running. If
no faults are displayed continue on to Step 21.
STEP 20
If any of these checks do not pass, the calibration will
be exited with a message displayed of the problem.
The top of the display will indicate RET or EXT along
with the Aux section number. The bottom of the
display will indicate fault:
Low Psi - AUX feedback pressure below expected
range
High Psi - AUX feedback pressure above expected
range
Psi Fault - Feedback pressure 1 and 2 outside
expected range
Cal Low - AUX valve crack point current calibrated
out of range low
Cal High - AUX valve crack point current calibrated
out of range high
Fault - Detected AUX solenoid valve short or open
during calibration
CAN Fault - ICU not present
Time Out - AUX feedback pressure drop was not
detected during the calibration period
Fault AUX k - Detected AUX solenoid valve short or
open prior to calibration
Section 55 - Electrical System, Controller - Chapter 6
RD06A172
55-6-63
STEP 21
The system will go automatically into the calibration
process when the pre-calibration is completed. The
screen will display each remote valve as it is
calibrated and will automatically cycle through all
remote valves in numeric order. The calibration
process for a five valve remote system will take
approximately five minutes. When calibration is
completed, the display will read Done. Push the
PROG key to return to the AUX Cal menu. If the
calibration process could not be completed, the
display will read the reason why. See Calibration
Process at the beginning of Aux Cal Menu.
MD05F177A