New Holland T8010 Manual page 1724

INCHING PEDAL SWITCH ADJUSTMENT
1
4
3
A. Install the switch (1) into the mounting bracket (2).
B. Turn the switch into the bracket until the tip of the switch plunger (3) is even with the mounting bracket.
C. Turn the switch an additional 2.3 turns so that the switch plunger protrudes from the bracket approximately
4.0 mm.
D. Tighten the switch locking nuts (4) to secure the switch in position. Connect the switch to the wire harness.
E. Turn the key switch to the ON position. Enter the TRANS VIEW menu in the display. Go to the inching
pedal potentiometer position menu to observe the pedal position.
F. Shift the tractor out of park. Slowly cycle the inching pedal while watching the display. The display should
read 100% when fully up and smoothly go down to 0% when fully depressed.
G. The switch should turn OFF and ON (make a click noise) between 5 and 15% clutch travel as shown on
the display.
H. If the switch does not activate between this range, loosen the lock nut (4) and turn the switch (1) as
required until the switch will activate between 7 and 14% of pedal travel as shown on the display. Tighten
the lock nut.
Section 90 - Cab, Hood, Seat - Chapter 1
2
RT97K033
90-1-3
1
4
2
RT97K034