New Holland T8010 Manual page 1676

Hide thumbs Also See for T8010:

Table of Contents

Trans View Mode

NOTE: Calibration can only be entered by pressing

and holding the PROG key within the first 10 seconds

of starting the tractor.

NOTE: If any fault codes are recorded, they must be

cleared before calibration is possible. Retrieve,

record and clear any fault codes. See Fault Code

Retrieval in this section.

Push and hold the PROG key for two seconds within

the first ten seconds after starting the tractor. A short

beep will indicate that the program mode has been

accessed and the display will read CONFIG MENU.

P u s h t h e D E C R k ey u n t i l t h e d i s p l ay r e a d s

TRANSMISSION and press the PROG key again.

Section 55 - Electrical System, Controller - Chapter 6

The display will read TRANS VIEW. Press the PROG

key to enter the Transmission View Menus.

The display will read VIEW CLTCH. Push the PROG

The display will read ODD mA. This displays the

calibrated clutch current values in milliamps. The

Odd clutch current value is displayed first. Push the

Chapters

Table of Contents

T8020 T8030 T8040