New Holland T8010 Manual page 1697

Hide thumbs Also See for T8010:

Table of Contents

Press the DECR key multiple times until FSUS

DEMO is displayed. Press the PROG key.

The display will read DEMO OFF, or DEMO ON. To

change status press INCR or DECR key. When the

status is correct press PROG key.

The DEMO allows the user to switch the Front

Suspended Axle ON or OFF especially at speeds

greater than 12 KMH.

Section 55 - Electrical System, Controller - Chapter 6

Front Suspension Manual Menu

NOTE: This menu will only work when the Electronic

Service Tool is in use.

Start the engine.

Push and hold the PROG key for two seconds within

the first ten seconds after starting the tractor. A short

beep will indicate that the program mode has been

accessed and the display will read CONFIG MENU.

Push the DECR key until the display reads TRANS

and press the PROG key again.

Chapters

Table of Contents

T8020 T8030 T8040