Trans Setup Mode
NOTE: Calibration can only be entered by pressing
and holding the PROG key within the first 10 seconds
of starting the tractor.
NOTE: If any fault codes are recorded, they must be
cleared before calibration is possible. Retrieve,
record and clear any fault codes. See Fault Code
Retrieval in this section.
STEP 40
Push and hold the PROG key for two seconds within
the first ten seconds after starting the tractor. A short
beep will indicate that the program mode has been
accessed and the display will read CONFIG MENU.
STEP 41
Push the DECR key until the display reads TRANS
and press the PROG key again.
Section 55 - Electrical System, Controller - Chapter 6
RD05G056
RD06A057
55-6-37
STEP 42
The display will read TRANS VIEW. Press DECR
key.
STEP 43
The display will read TRANS SETUP. Press PROG
key.
RD05F104
RD05F125