New Holland T8010 Manual page 1743

Hide thumbs Also See for T8010:

Table of Contents

Install the supply line to the left and right rear brake.

Continue to lower the cab onto the tractor chassis,

aligning the cab mount bolts with the holes in the cab

frame. Check for pinched cables, lines, or hoses.

Remove any tension on the cab lifting equipment.

Set the preload on the rear cab isomounts to a torque

of 47 to 61 Nm (35 to 45 lb. ft.) by holding the square

plate and tightening the bolt. Install the rear cab

mount washer and nut. Tighten the nut to a torque of

190 to 244 Nm (140 to 180 lb. ft.) on both sides of the

cab. Have an assistant hold the bolt, if necessary.

Section 90 - Cab, Hood, Seat - Chapter 2

Set the preload on the front cab isomounts using the

procedure in the previous step. Install the front cab

mount washer and nut. Tighten the nut to a torque of

190 to 244 Nm (140 to 180 lb. ft.) on both sides of the

Remove the cab lifting tool and rear cab lifting

brackets. Install the plastic plugs in the cab rear

window posts if required.

If equipped, connect the wire harness for the right

and left side mounted field lights.

Chapters

Table of Contents

T8020 T8030 T8040