Set I/O Path; Set Up The Measurement Parameters - Agilent Technologies 4396B Gpib Programming Manual

c b
Figure 1-3. Sample Program : Basic Measurement (2/2)

Set I/O Path

This operation allows you to use , instead of (or ), as the GPIB address in the
program.

Set Up the Measurement Parameters

You can execute GPIB commands in the same sequence as key operation. Lines 60
and 70 perform the same operation as pressing
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
4 Preset 5 4 Chan 1 5 4 Meas 5
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNNNNN .
4 Format 5
In general, the procedure for setting up measurements on the analyzer via GPIB follows the
same sequence as performing the procedure manually. There is no required order, as long as
the desired frequency range, number of points, and power level are set before performing the
calibration.
In line 70, several GPIB commands, separated by semicolon, are executed in a line. This is the
same as:
1-6 Learning GPIB Remote Control Basics